Connections, Operating And Display Elements Mix6Ag3 - LD Systems G3 Série Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS MIX6AG3

10
6 9
7 8
1
1
MIC INPUT CH1 – CH3
Balanced microphone input (combined XLR / 6.3 mm jack). It is also possible to use an unbalanced microphone cable (mono jack). There is
a switchable 15 V phantom power supply (switch no. 2).
2
PHANTOM ON / OFF
Switchable 15 V phantom power for the microphone inputs on channels 1 to 3 (CH1 – CH3) for use of a condenser microphone. In the ON
position, the phantom power is on, in the OFF position it is switched off.
3
HI-Z
This pressure switch can be used to change the channel 1 (CH1) input to high-impedance (press switch to activate). This allows channel 1
to be used as an instrument channel, e.g. for an electric guitar.
4
LINE INPUT CH4 (CINCH L/R)
Unbalanced line input with cinch sockets to connect an input device (e.g. laptop, MP3 player). This stereo input is internally set to mono.
5
LINE INPUT CH4 (3.5 MM STEREO JACK)
Unbalanced line input with a 3.5 mm stereo jack socket. This stereo input is internally set to mono.
6
HIGH
Equalizer high band (12 kHz) for input channels 1 to 4 (CH1 - CH4). Turn anti-clockwise to reduce the treble and clockwise to increase. In
central position (snap-in point) the equalizer is inactive.
7
LOW
Equalizer bass band (80 Hz) for input channels 1 to 4 (CH1 - CH4). Turn anti-clockwise to reduce the bass and clockwise to increase.
In central position (snap-in point) the equalizer is inactive.
8
LEVEL
Volume control for input channels 1 to 4 (CH1 - CH4).
13
12
11
14
6 9
7 8
3
1
15 16 17
6 9 6
7 8 7
1
5
19
20
21
18
9
8
22
4
23
2
5