Elem Co-Ligne MAX2300K-G Mode D'emploi page 8

regular basis.
Remove the carbon brush holders (7) and
clean the carbon brushes.
In case of wear, replace both carbon
brushes at the same time.
Mount the carbon brush holders.
After mounting new carbon brushes, let
the machine run at no load for 15 minutes.
Use only the correct type of
carbon brushes.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
No load speed min-1
Wheel diameter mm
Spindle thread M
Weight kg
LpA (sound pressure) dB(A)
LWA (acoustic power) dB(A)
Take appropriate measures for the protection of
hearing.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
extended use, do not put it
in the domestic waste but
environmentally safe way.
230
50
1,800
6,000
230
14
4.9
99
110
4.19 m/s2
replacement after
dispose of it in an
2010
8