Thermador T24UC925DS Guide D'installation page 10

5. Using a cordless drill, drill a ¹⁄₄" hole in the cold water pipe you have selected.
6. Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is
solidly in the ¹⁄₄" drilled hole in the water pipe and that the washer is under the pipe clamp.
Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so washer makes a
watertight seal. Do not overtighten or you may crush the copper tubing.
7. Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the
end of the tubing into the outlet end squarely as far as it will go. Screw compression nut
onto outlet end with adjustable wrench. Do not overtighten.
8. Place the free end of the tubing in a container or sink, and turn ON the main water supply.
Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper
tubing.
Connect to Refrigerator
1. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown.
Tighten the compression nut. Do not overtighten.
2. Turn shutoff valve ON.
3. Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.
4. The ice maker is equipped with a built-in water strainer. If your water conditions require a
second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a
water strainer from your nearest appliance dealer.
5. Plug in refrigerator or reconnect power.
A. Compressor nut
B. Plex tubing
After installing the appliance, wait at least 1 hour to turn on the appliance. During transportation the oil
in the compressor may have flowed into the refrigeration system.
Before switching ON the appliance for the first time, clean the interior of the appliance (see chapter
"Cleaning the appliance" in the Use & Care Guide).
Page | 10
A.
B.
G.
C.
D.
A. Cold water pipe
B. Pipe clamp
C. Shutoff valve
D. Copper tubing
E. Compression nut
F. Compression sleeve
G. Packing Nut
E.
F.