Picture Format - Schaub Lorenz LT32-25645 Instructions D'utilisation

9.2.3-PC Setting
Enter into the SETUP menu from the
Main Menu by pressing the MENU
button in the PC mode. In order to make
the necessary settings in this menu,
you can use the right-left, up-down
movement buttons on your remote
control. You can make the following
settings for your monitor in this menu.
9.2.4-HORIZONTAL POS: Horizontal
position setting
9.2.5-VERTICAL POS: Vertical position
setting
9.2.6-CLOCK
This is the pixel clock frequency. User
can narrow down or enlarge the display
by selecting a desired value.
9.2.7-PHASE
Using the right/left movement buttons,
you can ensure that the colors and
shapes are exactly consolidated on the
PC image.
9.2.8-AUTOCONFIGURATION
The most suitable geometric settings
in accordance with the entry mode
are configured by this function.
For this operation, select the
AUTOCONFIGURATION tab and
press OK button. You can adjust the
volume level of the source you have
connected to the Audio-In input at the
back of your TV by using the VOL+/
VOL- buttons.

9.2.9-PICTURE FORMAT

You can select the PC image to be
Connecting a Video recorder device and a digital satellite receiver
ANT IN
Scart 1 TV IN/OUT
ANT OUT
DIGITAL SATALLITE RECEIVER
ANT IN
Scart 2 AUX IN
displayed in 16:9, 14:9 or 4:3 formats.
Note 1: In the Monitor mode, you
can make the Brightness, Contrast,
Sharpness, Red, Green and Blue
Settings from the PICTURE menu.
Note 2: Some artifacts may appear in
the main screen when the PIP picture
is opened at high resolutions in the PC
mode.
Switching to the HDMI Mode
Connect to the HDMI input at the back
of your TV by using the connector
located on your PC or your digital video-
transmission device with a suitable
cable (not supplied with the TV).
Note 1: To be able to watch an image
in the HDMI mode on your Computer, it
must be equipped with a HDMI graphic
card.
You may display the resolution
information by pressing the INFO
button.
Note 2: Scart1 To connect a RGB-
supported external device to your
television, you must use a Scart cable
supporting RGB. If your external device
is supported in that case, you can set
the output as RGB.
HDCP (Optional)
Your TV supports HDCP feature. To
use this feature, you must set up a
connection to your TV set's HDMI video
port and select HDMI by pressing the
AV key on your remote control.
ANT OUT
SCART Socket
VIDEO RECORDER
22 I
k
ANT IN
REAR OF THE TELEVISION