Publicité
WPS button
Length of button press
Function
3-9 seconds
The WiFi Repeater ac is connected to the router.
1-3 seconds
A mobile device is connected to the repeater.
>10 seconds
All settings are reset to the factory default settings.
Behaviour of the device LEDs
LED behaviour
The bottom LED on the WiFi display is illuminated.
The bottom LED on the WiFi display flashes slowly.
The bottom LED on the WiFi display flashes quickly.
The LEDs on the WiFi display are illuminated continuously.
LED behaviour
The bottom LED on the WiFi display flashes quickly for a max. of 2 minutes.
The bottom LED on the WiFi display flashes quickly for a max. of 2 minutes.
The top four LEDs on the WiFi display flash briefly. The LED lights subsequently switch off and the device
restarts.
Status: The devolo WiFi Repeater ac ...
... is in the start-up process for a max. of 40 seconds.
1. ... is in an unconfigured state.
2. ... is configured via the web browser.
3. ... is no longer connected to the router after the configuration.
... is being configured via the WPS button.
1. ... is configured successfully.
2. . .. h as been set up successfully and is active. Depending on the signal strength, up to 5 LED indicators of
the WiFi wave symbol light up. Three illuminated LED indicators are indicative of an optimal location
for the devolo WiFi Repeater ac.
3. ... is in access point mode: All 5 LEDs light up.
| GB |
26 | 27
Publicité
