AEG NE 5609 Mode D'emploi page 25

Usage
1. Remove the transparent protection cap.
2. Slide the switch towards "OFF" in order to turn on the appliance.
• When the switch snaps audibly into place, the appliance works continuously.
• If you release the switch before it snaps audibly into place, the appliance will switch
off again.
3. Guide the tip of the shaving head into the nostril or auricle.
WARNING:
Only remove the prominent nose or ear hair. Do not forcefully push the appliance
into the nostril / auricle. You can hurt yourself when it is inserted too deep!
4. Slide the switch back towards "ON" after usage in order to switch off the device.
5. Clean the shaving head with the cleaning brush after usage.
6. Put the transparent protection cap back on.
Cleaning
WARNING:
• Do not submerge the unit in water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
1. Switch off the appliance before cleaning.
2. Remove the battery from the battery compartment.
3. Loosen the shaving head by turning it anticlockwise and remove it.
4. Remove remaining hair from the blade holder using the cleaning brush. You can also
blow off the remaining hair from the holder.
5. Place the shaving head onto the blade holder again. Turn it tight clockwise until it
snaps audibly into place.
6. Put the transparent protection cap back on.
Noise emission
The workplace-related emission value is less than 70 dB(A).
English
25