schmersal SLC 210 RF Instructions De Montage page 69

RECEIVER (BLINKING SYMBOLS)
7 SEGMENTS DISPLAY
SYMBOL MEANING
Displayed alternatively
F
to the error code
3
Internal error
4
A
OSSD1 - OSSD2 short-circuit
6
OSSD static outputs error
5
Interfering dangerous
Emitter detected.
The receiver is able to receive
I
simultaneously the beams from
two different Emitters
(only for MASTER models)
U
SLAVE connections incorrect
(only for MASTER and
STANDARD models)
0
Overload of the OSSD static
outputs
(only for MASTER and
STANDARD models)
H
User configuration changed
without system restart
LED
RED GREEN YELLOW
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
REMEDY
Send the equipment for repair
to SCHMERSAL.
Take action in one of the following
ways:
(STANDARD and MASTER
MODELS)
Carefully check the connection of
terminals 1 and 3 (OSSD) on the
connector.
(SLAVE MODELS)
Send the equipment for repair to
SCHMERSAL.
Take action in one of the following
ways:
(STANDARD and MASTER
MODELS)
Carefully check the connection of
terminals 1 and 3 (OSSD) on the
connector. If necessary, adjust
load reducing the current required
to max 500 mA (2 F).
(SLAVE MODELS)
Send the equipment for repair to
SCHMERSAL.
Carefully locate the interfering
Emitter and take action in one of the
following ways:
Reduce the emitter range from
high to low.
Switch the position of the Emitter
and Receiver.
Move the interfering Emitter to
avoid this illuminating the
Receiver.
Shield the beams coming from the
interfering Emitter using opaque
protections.
Carefully check the MASTER-SLAVE
connections.
Carefully check the connection of
terminals 1 and 3 (OSSD) on the
connector.
Operate a system restart.
33