Fixing The Telescopic Flues; Ducting Mode - sauter SHD601 Guide D'installation Et D'utilisation

2 / INSTALLING YOUR APPLIANCE

FIXING THE TELESCOPIC FLUES

•

Ducting mode

•
- Adjust the width of the support bracket (D) of the
telescopic flue by means of the screws (E) as
shown in fig.7.
- Then, by means of the screw anchors and
screws (F) provided, fix the bracket to the ceiling
in such a way that it is positioned along the axis with
your hood.
- Connect the air outlet pipe to the air vent of the
hood; use a flexible pipe and lock it to the air vent
of the hood with a metal hose clamp - fig. 8 (pipe
and clamp are not provided).
- For ducting hoods, turn the upper flue over so that
the air exhaust grid is in the lower section (fig. 9).
- Plug in the hood.
- Insert the telescopic flues setting them on the
hood; extend the upper flue to the ceiling and
secure with the 2 screws (H) - fig. 10.
Warning
This is the filtering version of your
cooker hood; you must first remove the
charcoal filter.
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
125 mm-diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In
the event that the hood will be operated
using out-door evacuation, you should
ensure a sufficient inflow of fresh air to
avoid a pressure deficiency in the room. fig. 9
25
EN
fig. 7
fig. 8
fig. 10