YBA Genesis A6 Manuel D'utilisation page 7

Discovering your A6: Rear view continued
1
Speaker connections. Check the polarity: the + of your speaker must be connected to the + of the A6.
Connect your RIGHT speaker to the R output of your A6 and the LEFT speaker to the L output of your A6.
We recommend the use of banana plugs to prevent short-circuit. This device has been designed to be
used with 8 or 4 ohm speakers.
2
RCA and Balanced Audio inputs: Connect the RCA or balanced outputs of your source to the RCA or
balanced inputs of your A6. Be sure to connect the RIGHT output of your source to the R input of your
amplifier and the LEFT output to the L input of your amplifier.
3
Power inlet: Connect provided mains cable. Be sure your A6 switch is in OFF position before plugging or
unplugging the mains cable.
SPECIFICATIONS
Audio Outputs
Power Output
SNR
Frequency Response
THD+N (20Hz - 20kHz)
Inputs
Power Supply
Dimensions (w x d x h)
Weight
1 Pair Speaker Outputs
150W @ 8 Ohms per channel
250W @ 4 Ohms per channel
>95dB
20Hz - 20kHz (-0.5dB)
<0.1%
1 RCA, 1 Balanced
Linear power supply with high performance UI-Core transformer 500VA
430mm x 402mm x 175mm
21 kg
www.ybahifi.com
Genesis A6 Power Amplifier
Page 7