Troubleshooting; Operating Instructions; Remote Control Unit (Rc-1022) - Denon PMA-1500AE Mode D'emploi

ENGLISH

Troubleshooting

Check the following before assuming there is a problem with the set.
1. Are all connections proper ?
2. Is the set being operated as described in the operating instructions ?
3. Are the speakers and input components being operated properly ?
If the set does not seem to be operating properly, check the points listed below. If these points do not apply, the set may be damaged.
Turn off the power immediately and contact your store of purchase.
Symptom
Power indicator does not light and
no sound is produced when
POWER switch is turned on.
Power indicator lights but no
sound is produced.
Sound is not produced from one
side only.
Volume level is different when
listening to tuner and records.
Positions of instruments inverted
for stereo sources.
Booming sound produced when
playing records.
Howling produced when volume is
turned up while playing records.
Sound is distorted.
This unit is not operated properly
when remote control unit is used.
Cause
• Power supply cord is not connected.
• Speaker cords not properly connected.
• INPUT SELECTOR knob or P. DIRECT
switch is not set to proper position.
• VOLUME control knob turned down.
• Speaker cords not properly connected.
• Input cords not are properly connected.
• Left/right balance improperly adjusted.
• Tuner or record output is different.
• Left and right speakers or input cords
the inverted.
• Turntable's ground wire is not
connected.
• Input cords are not properly
connected to PHONO terminals.
• Influence from a TV or VCR near the
turntable.
• Turntable and speaker systems are too
close.
• Floor is soft and vibrates easily.
• Stylus pressure is too light.
• Dirt on tip of stylus.
• Defective cartridge.
• Batteries are dead.
• Remote control unit is too far from
this unit.
• Obstacle between this unit and
remote control unit.
• Different button is being pressed.
• < and > ends of battery is inserted in
reverse.
11
ENGLISH
Measures
• Check that the cord is plugged in.
• Connect securely.
• Set to the proper position.
• Set to an appropriate level.
• Connect securely.
• Connect securely.
• Adjust the BALANCE control knob.
• Adjust the tuner output to the
turntable's output (if the tuner is
equipped with an output control).
• Check the left/right connections.
• Connect securely.
• Connect securely.
• Change the position of installation.
• Move speaker systems as far away as
possible.
• Use cushions to absorb the vibrations
transmitted from the floor to the
speakers. If the turntable does not
include insulators, use audio
insulators, available in stores.
• Apply proper pressure.
• Check the tip of the stylus.
• Replace the cartridge.
• Replace with new batteries.
• Move closer.
• Remove obstacle.
• Press the proper button.
• Insert batteries properly.
Page
8
7
4
4
8
8
4
–
8
8
8
–
–
–
–
–
–
3
3
3
6
3