Finding New Stations - Dab; Autoselect - Dab - Sangean DCR-9 Mode D'emploi

Finding new stations - DAB

As time passes new stations may become available. To find new
stations proceed as follows:-
1. Press and release the AutoTune button, the display will show
"Autotune Quick Scan". Your radio will perform a scan of the DAB
frequencies. As new stations are found the station counter on the
right-hand side of the display will increase and stations will be added
to the list
2. To carry out a full scan of the entire DAB Band III frequencies press
and hold down the AutoTune button for more than 2 seconds and
then release. The display will show "Autotune Full scan". As new
stations are found the station counter on the right-hand side of the
display will increase and stations will be added to the list

Autoselect - DAB

As an alternative to pressing the tuning control to select a station your
radio can be set so as to automatically select a station.
1. Press either the Tuning up or down buttons a few times,
immediately press and hold in the Select button until the display
shows "Autoselect ON".
2. Scroll through the tuning list using the Tuning up or down buttons
until the station you require is visible on the display, after a few
seconds your radio will automatically select the station shown on
the display.
3. To switch off Autoselect press either the Tuning up or down
buttons a few times, immediately press and hold in the Select
button until the display shows "Autoselect OFF".
9