Safety Instructions - Uniteck UNIFIX 20.1 WB Mode D'emploi

SAFETY INSTRUCTIONS

• Take appropriate measures to prevent accidents during assembly work.
• If the panel and support are exposed to sunlight for a long period of time, there is a risk of
burns. Protect yourself.
• At the end of the work, check that your supports and panels are firmly attached.
RECOMMENDATIONS
• Mount the Unifix brackets only on balconies or handrails with sufficient bearing capacity. Take
into account the additional load with panel:
- Installation 10W: (Unifix 20.1 WB (1,3kg) + Unisun 10.12M (1,2 kg)): 2,5 kg
- Installation 20W: (Unifix 20.1 WB (1,3kg) + Unisun 20.12M (2,2 kg)): 3,5 kg
• Unifix supports are exclusively intended for fixing Unisun panels.
• The arrangement of the sensors influences your electrical performance. Choose the optimum
tilt and orientation according to your environment. Avoid areas of shade or objects that may
cause shadows.
• For more energy, it is possible to use two solar systems:
- panels with the same orientation: installation in parallel (two panels + one regulator +
one wiring kit + branch connectors)
- panels with opposite orientations: two separate installations (one panel + one panel +
one
controller + wiring kit) x2
PREPARATION OF UNIUN PANELS
Unisun panels may require 4 holes D=8 of the aluminium frame according to the following centres:
120 mm
260 mm
www.uniteck.fr
Unisun 10.12M ou 20.12M
EN
5/11