DAEWOO ELECTRONICS FRN-Q19D Série Notice D'emploi page 10

Replacing Refrigerator Door
1 Insert the bottom hole of the refrigerator door
straight into the bottom hinge pin.
2 Let the top of the door close and insert the top
hinge pin to the top hole of the refrigerator door.
(Insert the back of hinge to the groove of protrusion
first, then front to the top hole of door.)
3 Turn the hinge fastener tightly to the end. Connect
harness wirings (model dependent) and screw
down the ground wire. Click and screw the top
hinge cover.
6 | EN
Replacing Freezer Door
1 Insert the water tube into the hole of the bottom
hinge pin first(Dispenser Models Only). Insert the
bottom of freezer door into the bottom hinge pin.
2 Let the top of the door close and insert the top
hinge pin to the top hole of the freezer door. (Insert
the back of hinge to the groove of protrusion first,
then front to the top hole of door.)
3 Turn the hinge fastener tightly to the end. Connect
harness wirings and screw ground wire.
4 Click and screw the top hinge cover
5 Fasten the bending tube guide and insert the water
tube far into the coupling. (Dispenser Models Only)