Technical Information - ASTi Sound+Sleep SE Mode D'emploi

TECHNICAL INFORMATION

Specifications
Sound Categories 16
Sound Environments: 64
Speaker Compensation: Five-band parametric EQ
Headphone Jack: 3.5mm stereo
Audio input jack: 3.5mm stereo
USB-A charging ports: 900 mA max (each)
Power requirements: 5 Volts, 2.5 Amps DC max.
when charging other devices
Power consumption while off: < 0.25 Watts
(typically 0.1 Watts)
TROUBLESHOOTING
Symptom Possible Cause
• Disconnected power plug
No operation when
POWER button is pressed
• Unit is connected to a switched wall outlet
• Faulty wall outlet
• System needs to be reset
• Volume is set too low
Unit is On, but no sound is heard
• Cable plugged into external audio input?
• Headphones plugged in?
• Volume is set too low
Unit is On, but volume is too low
• In Adaptive Mode?
Volume is too high
• Try the "Factory Reset" procedure.
Other unexpected behavior
If this does not resolve the issue,
call Customer Support
7
Restore Factory Settings
This procedure will reset the unit to its original
"out of the box" settings.
1. Turn off the Sound+Sleep SE
2. Press and hold the POWER button for about five
seconds, until you hear a small popping sound.
Customer Support
If you have problems or questions, please visit:
www.astisupport.com
Solution
Check the power connection on the bottom of the unit and
at the wall outlet. Make sure that both are firmly seated
Move the unit to an un-switched outlet
Move to a working outlet and power on again
First, power Off the unit, then press and hold the POWER
button for 5 seconds
Press or hold VOLUME-UP button to increase volume
Remove cable from Audio Input Jack, or connect cable to
audio source
Remove headphones, speaker is muted when headphones
are connected
Press or hold VOLUME-UP button to increase volume
In Adaptive Mode the sound will be low when there is no
noise in the room. If you prefer to maintain the sound on high
volume, turn Adaptive Mode Off.
Press or hold the VOLUME-DOWN button to decrease volume
1. Unplug power adapter from the AC outlet
2. Press and hold the POWER button down while plugging
power adapter back into AC outlet
3. Continue to hold POWER button down for 5 seconds
SAFETY, WARRANTY, AND CERTIFICATIONS
Safety Instructions
Read and adhere to all safety and operating instructions before use. Keep this
booklet for future reference.
1. WARNING: Do Not Operate Heavy Machinery or Motor Vehicles While Using
this Device.
2. The unit should be cleaned regularly with a soft, dry cloth. The grill may be
vacuumed to remove excessive dust or particle build-up. Do not use any liquids
or sprays (including solvents, chemicals or alcohol) or abrasives to clean.
3. The unit should not be used near water, such as a bathtub, swimming pool, faucet
or basin to avoid electrocution.
4. Be careful to avoid dropping objects or spilling liquids onto the unit. If liquid is spilled
on the unit, unplug and turn it upside down immediately. Allow it to dry thoroughly
(one week) before plugging it into a wall outlet again. Following these instructions
does not ensure that the unit will be operational.
5. Do not reach for the unit if it has fallen into water. Unplug it immediately at
the wall outlet, and if at all possible drain water before retrieving the unit.
6. The unit should be situated away from heat sources such as radiators, heat
registers, stoves or other appliances (including amplifiers) that produce heat.
7. Avoid placing the unit in areas that are exposed to direct sunlight or close to
heat-radiating products such as electric heaters. Do not place unit on top of
stereo equipment that radiates heat.
8. Avoid placing in areas that are dusty, humid, moist, lack ventilation, or are
subject to constant vibration.
9. The unit may be subject to interference from external sources such as
trans-formers, electric motors or other electronic devices. To avoid distortion
from such sources, place the unit as far away from them as possible.
10. Do not apply excessive force when using any switches or controls.
11. The unit should only be used with the power adapter provided or AA batteries.
12. Power cords should be routed to avoid being walked on or pinched by items
placed on or against them.
13. Unplug the power adapter from the outlet when the unit is unused for long
periods of time or when moving the unit.
14. Do not attempt to service the unit yourself.
One Year Limited Warranty
Adaptive Sound Technologies, Inc., hereinafter referred to as ASTI, warrants this
product against defects in materials and/or workmanship under normal use for
a period of ONE (1) YEAR from the date of purchase by the original purchaser
("Warranty Period"). If a defect arises and a valid claim is received within the
Warranty Period, at its option, ASTI will either 1) repair the defect at no charge,
using new or refurbished replacement parts, or 2) replace the product with a current
product that is close in functionality to the original product. A replacement product
or part, including a user-installable part installed in accordance with instructions
provided by ASTI, is covered by the remaining warranty of the original purchase.
When a product or part is exchanged, the replacement item becomes your property
and the replaced item becomes ASTI's property.
Obtaining Service: To obtain warranty service please call, or email Adaptive
Sound Technologies.
Limits and Exclusions: This Limited Warranty applies only to the ASTI Sound+Sleep
SE unit, ASTI power adapter, ASTI power cable, and ASTI audio cable. It does NOT
apply to any bundled non-ASTI components or products.
This warranty does not apply to: a) damage caused by failure to follow instructions
relating to the product's use or to the installation of components; b) damage
caused by accident, abuse, misuse, fire, floods, earthquake or other external causes;
c) damage caused by service performed by anyone who is not a representative of
ASTI; d) accessories used in conjunction with a covered product; e) a product or part
that has been modified to alter functionality or capability; f) items intended to be
periodically replaced by the purchaser during the normal life of the product including,
without limitation, batteries or light bulbs; or g) any and all pre-existing conditions that
occur prior to the effective date of this Limited Warranty relating to any product sold
"as is" including, without limitation, floor demonstration models and refurbished items.
ADAPTIVE SOUND TECHNOLOGIES, INC. SHALL NOT BE LIABLE FOR INCIDENTAL
OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR
ARISING OUT OF ANY BREACH OF THIS WARRANTY. TO THE EXTENT PERMITTED
BY APPLICABLE LAW, ASTI DISCLAIMS ANY AND ALL STATUTORY OR IMPLIED
WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MERCHANTA-
BILITY, FITNESS FOR A PARTICULAR PURPOSE AND WARRANTIES AGAINST HIDDEN
OR LATENT DEFECTS. IF ASTI CANNOT LAWFULLY DISCLAIM STATUTORY OR
IMPLIED WARRANTIES, THEN TO THE EXTENT PERMITTED BY LAW, ALL SUCH
WARRANTIES SHALL BE LIMITED IN DURATION TO THE DURATION OF THIS
EXPRESS WARRANTY.
Some geographic areas disallow the exclusion or limitation of incidental or
consequential damages or the length of an implied warranty. As a consequence,
some of the above exclusions or limitations may not apply to buyers residing in
those areas. This warranty grants specific legal rights to buyers, but other rights
may also be granted, which vary from country to country, state to state, etc.
FCC Declaration
This equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from
the one to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
© Adaptive Sound Technologies, Inc. All Rights Reserved. Sound+Sleep, Adaptive Sound,
and the ASTI logo are trademarks of Adaptive Sound Technologies, Inc. All other marks
are trademarks or registered trademarks of their respective owners. Use of this product
is protected by US patents #8,243,937, #8,379,870, #8,280,068 and #8,280,067. Additional
patents pending.
8