GreenWorks Commercial GTL100 Manuel Opérateur page 7

8.1.1 INSTALL THE TINES
The cultivator has four tines —two inner tines stamped
B and C and two outer tines stamped A and D. For
correct operation of the unit, the tines must be installed
in the correct orientation.
1. Place the large felt on each side of the tine shaft,
and slide to rest against the inner tine.
2. Put the machine on a flat and smooth surface.
3. Place tine B on the tine shaft to the left of the gear
box. The stamped side of the tine should face away
from the gear box.
4. Place tine C on the tine shaft to the right of the gear
box. The stamped side of the tine should face away
from the gear box.
5. Place the small felt inserts on each side of the tine
shaft, and slide to rest against the inner tine.
6. Place the outer tine stamped A on the left side of the
tine shaft. The stamped side should face in toward
tine B.
7. Place the outer tine stamped D on the right side of
the tine shaft.The stamped side should face in
toward tine C.
8. To secure the tines to the tine shaft, insert the ring
pins into the holes located on either side of the tine
shaft.
NOTE
The unit will not operate properly if the tines are
installed incorrectly. If you notice a problem with the
cultivating operation of the unit, check for proper tine
positioning.
WARNING
The tines and the machine may damage even if you
move the machine with the motor switched off. To
prevent the tines from touching the ground while
moving please tilt the machine.
English
8.1.2 ADJUST THE WHEEL HEIGHT
The wheels are used to control the depth of operation.
To adjust the height of the machien, move the wheel
assembly into to a higher or lower hole position.
1. Pull and rotate the knob for 90°.
2. Move the wheel assembly to your desired hole.
3. Rotate the knob until the knob locks into place.
8.1.3 INSTALL THE HANDLE
1. Insert the left handle into the support rod.
2. Allgn the holes in the panel with the holes in the left
handle.
3. Insert the screws into the panel and use the phillips
screwdriver to tighten them.
4. Insert the bolt through the top of the support rod.
5. Use the wing nut to tighten it.
7
EN