Adjusting The Angle; Storage, Cleaning - Crivit SL-8594 Mode D'emploi Rapide

Assembly
Footrest frame assembly
Note: Keep the lounger folded while assem-
bling the footrest frame.
1. Remove the cable binders and the packaging
material.
2. Pull the inner rods (1b) out of the main frame (1a).
3. Insert the narrow ends of the inner rods into
the end of the footrest frame (2) until the holes
are directly above one another (fig. B).
4. Fix the inner rods and the footrest frame using
the screws (6) (fig. C).
5. Insert the footrest frame into the main frame
with the bracket facing downwards (fig. D).
6. Screw the cross bar (1c) to the footrest frame
(fig. E).
Note: Make sure that the bracket on the foot-
rest frame is facing downwards.
Wheel assembly
1. Insert the pin (10) into the hinge (1d). The pin
should be inserted far enough into the hinge
that the threaded hole and the hole on the axle
rod are exactly above one another (fig. F - G).
2. Now fasten the short screw (7) in the thread-
ed hole (fig. G).
3. The wheel (4) is now pushed onto the pin and
fixed using the washer (8) and the cap nut (9)
(fig. H). Use the included tools for this task.
Sunroof assembly
1. Loosen the pre-mounted locking screws and
the sleeves from the rod (5).
2. Insert the longer screw through the main frame
from the inside to the outside.
3. Attach the sleeve with the wider pipe insert and
fasten the rod with the locking screw (fig. I).
4. The sunroof (3) is fixed in the same way
using the shorter screw and the sleeve with
the narrower pipe insert.
Using as a Transport Aid
To use the article as a transport aid, fold the sun
shade down so that it lies flat on the surface of
the article, and then raise the foot frame (fig. J).
The maximum carrying capacity is 20kg.

Adjusting the Angle

The angle of the backrest can be set to one of 5
levels (fig. K). Fold the back support completely flat
down onto the seat and then pull up horizontally.
You will hear audible ratchet sounds as you pull it
up, enabling you to select the angle of incli-nation
in individual steps. To reset the angle fold the back-
rest up past the vertical and then back down again.

Storage, cleaning

When not in use, always store the product
clean and dry at room temperature. Only clean
the product with a damp cloth and wipe dry
afterwards.
IMPORTANT! Never clean the product with
harsh cleaning agents. Maintenance! Check the
bolted connections regularly.
GB/IE 9