Safety Warnings For Wet/Dry Vacuum Cleaner; Danger Levels; Connection To The Electricity Grid - TMB TOP Série Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

SYMBOLS USED IN THE MANUAL ..........................................................14
ENVIRONMENT PROTECTION .................................................................14
TECHNICAL DATA TABLE KEY ................................................................14
COMPLIANT USE .......................................................................................14
PARTS OF THE APPLIANCE .....................................................................14
INITIAL OPERATION OF THE APPLIANCE ..............................................14
EMPTYING THE COLLECTION TANK ......................................................15
MAINTENANCE ..........................................................................................15
TROUBLESHOOTING ............................................................................... 15
EC DECLARATION OF CONFORMITY .....................................................35
TECHNICAL DATA .....................................................................................34

DANGER LEVELS

DANGER: Indicates an imminent danger
that could cause serious injury or death.
WARNING:
Indicates
dangerous situation that could cause
serious injury or death.
CAUTION:
Indicates
dangerous situation that could cause
minor injuries.
ATTENTION:
dangerous situation that could damage
objects.
DANGER:
and warning indications before using. This vacuum cleaner has been designed to be safe
components is found, the vacuum cleaner and/or the accessory must be repaired at the
relative authorised service centre or else at the manufacturer before use, in order to prevent
further damage to the appliance or physical injury to the user.
Before connecting the appliance to the electricity socket, make sure the electrical information
on the plate corresponds to that of the mains supply. The appliance must only be powered
with alternating current and voltage equal to that shown on the serial number plate.
The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
Before using, check for any damage on the connection cable and on the power plug. If the
cable is damaged, immediately contact a specialist technician for restoring normal operations.
Connect the appliance only to an electrical connection installed by an electrical installer in
conformity with IEC 60364-1.
Never touch the power plug with wet hands.
Make sure that the cable to the mains or the extension cable have not been damaged by
having been walked on, crushed, pulled or the like. Protect the cable from heat and from
contact with oils or sharp edges.
Regularly check that the cable connecting to the mains is not damaged, for example with signs
of ageing or cracks. If there is damage, the cable must be replaced by a specialist TMB srl
Protection against splashes of water and the mechanical strength need to be ensured also
a
probable
a
probable
Indicates
a
probable

CONNECTION TO THE ELECTRICITY GRID

ENGLISH
The descriptions contained in this document are not binding. The company therefore reserves the
necessary for reasons of improvement or manufacturing/commercial requirements. The reproduction,
even partial, of the text and drawings contained in this document is prohibited by law.
SAFETY WARNINGS FOR WET/DRY
VACUUM CLEANER
time, read and comply with these
warnings for consultation in the future
or to hand them over to successive
owners.
Before commissioning, read the appliance's
user manual.
The warning plates on the appliance provide
important instructions for its safe use.
Always comply with both the directions on
the instructions, as well as current safety
standards.
10

Publicité

Table des Matières
loading

Table des Matières