DURAVIT B.1 Série Notice De Montage Et D'utilisation page 8

9
The hot valves can cause
CAUTION
scalding
> Avoid contact.
NOTICE
Likelihood of confusion
> Connect cold water valve with the supply line
with blue dot and hot watervalve with the
supply line with red dot.
> Attach supply lines to shutoff valves.
11
> Clean the drain opening at the bottom of
sink.
> Place the waste seat in opening of the sink.
8
MAL_57158/20.10.4
10
CAUTION
Cut and crush injuries
> Wear gloves during installation.
> Attach the other ends of supply lines to shut
off stop.
> Using adjustable wrench (19 mm), tighten
the lines to stops (Maximum torque
5.9ft-lbs.).
12
> From the underside of the sink, thread the
drain body into the waste seat.
> Drain assembly should only be hand
tightened. Duravit recommends the use of
silicone or acid free putty.
8 Nm
5.9 ft-lbs.
19 mm