ECS Electronics RN-009-BB Instructions De Montage page 3

1.
Remove the battery earth cable.
Remove the covers at the left- and right-hand side under the rearlights.
2.
Drill a 13 mm large hole at the right-hand side in the spare wheel housing.
Carefully remove all metal particles and treat the edges with anti-rust.
Put the rubber grommet in the hole.
3.
Route the wiring harness in the boot.
Lead the 8-pole end through the grommet to the socket.
Pull the rubber coverplate over the wiring harness.
Remove the contactholder from the socket and fit the wires as indicated:
DIN/ISO
1724
1/L
2
3/31
1-8
4/R
5/58-R
6/54
STOP
7/58-L
8/58-b
Mount the socket to the towbar.
4.
At both rearlight units connectors are located.
Disconnect these connectors.
Connect the connectors of the wiring harness with the grey, green, brown
and blue wire at the right-hand side.
Connect the connectors of the wiring harness with the grey, black, red and
yellow wire at the left-hand side.
Tie the connectors with the supplied cable ties, to make sure they don't get
loose (see picture).
Fit the ringtongue with the white wire at the right-hand side to chassis earth.
5.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
© ECS 2000
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 12-N SOCKET UP TO
DIN/ISO NORM 1724
RENAULT MEGANE 5-D 1999-
Partno.: RN-009-BB
D F
gelb jaune
bleu
blau
weiß blanc
grün vert
braun marron
rot rouge
schwarz noir
grau gris
RN-009-BB-E 170100L
GB NL
yellow geel
blauw
blue
white wit
green groen
brown bruin
red rood
black zwart
grey grijs
Connector
wiring harness
Cabletie
Connector
vehicle
revisie 1