The Controller Mode 2; Charging Of The Helicopter; Preparation; Flying - ACME zoopa 300 Movie Manuel D'utilisation

zoopa 300 Movie

The controller MODE 2

Camera
! !
The antenna of the 2.4 GHz system is not extendable.

Charging of the helicopter

» Remove the battery from the helicopter.
» Connect the battery to the LiPo Charger and plug it into the socket.
» Charging is displayed by a red LED light. It takes about 2 hours. As soon as charging is finished, the LED turns green.
! !
Stop using the model as soon as the battery gets weak.

Preparation

» Insert batteries into the controller (batteries not included).
» Connect the battery plug with the helicopter´s socket.
» Place the helicopter on an even surface, so that the tail rotor points into your direction. Check if any obstacles could affect the flight.
» Step back for at least three metres.
» Switch on the controller and move the accelerator forwards.

Flying

The controller has a range of about 30 m. If the helicopter is out of range, the helicopter automatically switches into "fail save mode".
The motor then runs with only 30 % to make sure the landing will be save.
Avoid crashes and flying under ceilings – this may lead to a crash and damage the helicopter.
Be conscious and careful about your actions. Keep your face, eyes, hands, hair and loose clothing away from the blades. Never take
your eyes off the helicopter. Keep a safe distance. In case the helicopter crashes, the swash plate can be damaged. Please check
before taking off again. Fly only outside when there is no wind. Also, never fly outside when it is wet.
Handhold
Antenna
Camera control
Light on/off
Trimming wheel
Power Indicator
Throttle and rudder
Elevator and aileron
Power on/off
12