Using The Machine - EUROPASTYLE HSM 800 Mode D'emploi & Garantie

5....-05-HSM 800 NEU
Fine Adjustment of the Voltage
In case of voltage fluctuations in the mains it may be necessary to adjust the
machine. Switch the machine on. Turn the voltage adjustment screw (6) with a scr-
ewdriver or small coin so that the machine runs as quietly as possible.
Preparing for Cutting
1. Briefly comb the hair.
2. Remove the blade protection.
3. Oil the blades slightly.
4. Place a cutting length guide suitable to the desired cutting length. If you are not
sure of the cutting length, start from 12 mm. Insert the blades in the slot and fit
the attachment on the blade.
5. Insert the plug in a duly installed 230V/50Hz protective contact socket, switch
on the device and run the device with the guide comb upwards and at a con-
stant speed through your hair. The guide is held in a level position.
Cutting without Cutting Length Accessory
This is suitable for trimming the hair. The cutting length can be adjusted continuous-
ly in the range of approximately 0 - 1.2 mm.
For areas which are not accessible to the razor it is possible to use a pair of scissors.
IMPORTANT: Do not use the device for more than 10 minutes. Allow the equipment
to cool down for 10 minutes, before using it again.
• Disconnect the machine from the mains.
• Clean the device after use with a dry cloth. Then wipe off again with a dry cloth.
• The blades and accessories should be cleaned with the brush.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
17.04.2003 10:00 Uhr

Using the Machine

Cleaning
Seite 23
GB
23