shark DuoClean Powered Lift-Away AZ1002C Guide D'utilisation page 6

MAINTENANCE
Self-cleaning brushroll
The self-cleaning brushroll removes long hair, short hair, and pet hair while you clean. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
NOTE: If you see some hair wrap on the brushroll, just keep vacuuming, and the self-cleaning
brushroll will send it to the dust cup.
CLEANING THE BRUSHROLL
To open the brushroll garage, slide both release buttons on the floor nozzle away from you,
towards the back of the nozzle, then lift off the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then
push down on both sides of lid until it clicks securely into place.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow the self-cleaning brushroll to remove it for you.
Use CARPET/LOW PILE mode on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning brushroll
to remove the hair wrap and send it to the dust cup. If some fibers remain wrapped around brushroll after continued use, carefully
remove the debris from the brushroll.
CLEANING THE SOFT ROLLER
To remove the Soft Roller from the nozzle, lift it
out by the pull tab. Tap loose debris off the Soft
Roller. Use a dry towel to wipe the Soft Roller
clean, or to remove any debris caught in the
teeth behind the Soft Roller.
sharkc le a n.com
Hand wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least 24
hours. Reinsert the Soft Roller under the rubber
bumper in the front of the nozzle until it clicks
into place.
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check hose and
opening on back of pod for blockages.
Detach wand from floor nozzle, tilt nozzle neck back,
and check opening for blockages.
Detach wand from floor nozzle and handle, and
check both ends for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
s ha rkc l ea n.co m