König Electronic CMP-REPEATVGA2 Mode D'emploi page 4

Connection and operation
• Connect the single VGA source to the main VGA input using a length of VGA cable
• Connect VGA output of the sender to a local display and audio output of the sender to a local sounder
• Connect sender and each receiver using a piece of CAT-5e/6
• Connect VGA outputs of receivers to remote displays and audio output of receivers to remote
sounders
• Plug one 5 V @ 2 A power supply into the VGA UTP 1X 1 splitter and the other 5 V @ 2 A power
suppliers to receiver
Attention: Insert / Extract cable gently
Connection Diagram
VGA IN AUDIO
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Computer
VGA OUT
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
from mains and other equipment if a problem should occur. Do not expose
AUDIO
Cat 5e/6 Cabel
4
Display
VGA OUT AUDIO