König Electronic CMP-REPEATVGA2 Mode D'emploi page 2

Introduction
This VGA UTP extender 1X 1 splitter with audio is an ideal device for local displaying and remote
viewing. It combines split function and extension function. It distributes the input of the VGA signal
and audio signal into the local and remote outputs simultaneously. Receiver by Cat5x 1 works with the
sender as a full functional module by receiving the distributed signal from the sender and transmitting
to display. Only by using a CAT6 cable the full extension of the VGA signal up to 300 metres can be
reached.
Features
This device has many features that enable it to perform in a superior manner. Among these features
you will find:
• Extend VGA video and stereo audio signal to maximum 300 meters over one UTP cable with cross
stand inside. (don't use a UTP cross cable, use a straight UTP cable).
• Adjusting GAIN and PEAK to adapt for the different length of UTP cable.
GAIN: Brightness adjustment.
PEAK: Skew adjustment.
• Supports a maximum resolution of 1920x1200.
• Dual output at local unit: 1x VGA output for local site, plus 1x UTP output for remote site.
Specifications
Input /Output connector
Input connector
Output connector
Operating Frequency
Vertical frequency range
Resolutions (pc)
640X480
800X600
1024X768
1280X720
1280X768
1280X960
1280X1024
1600X900
1600X1200
1920X1080
1920X1200
Mechanical
Size of VGA UTP extender 1X 1 splitter
Weight of VGA UTP extender 1X 1 splitter
Size of receiver (L-W-H)
Weight of receiver (Net)
ENGLISH
VGA (Female 15pin), stereo audio
VGA (Female 15pin),
stereo audio, 1x RJ45
60/75/85Hz
100×65×25.5 mm
208 g
81.5×43×23 mm
108 g
2