Operation And Functions; Connection For Water Evaporators (Thermal); Starting Up - ISC HC 10 D Mode D'emploi

HC 10_D_mehrp_neu
GB
Connection for fine atomizers
(thermal)
When using a thermal evaporator (all bioactive
sauna heaters), Nhum has to be connected to N
oven and Lhum to WB (water bath) in the oven.
Important! The terminal WM (water shortage) is not
assigned!
5
.
.
.
.
.
.
.

Operation and functions

Description of the operating elements
No.1 Operating switch
No.2 Control factor regulator
No.3 Operating status indicator
No.4 Button for temporary operation
10
13.01.2006 10:00 Uhr Seite 10
Operating display indicators
LED Indicator
color lights up
Green X
Red X
No indication
Important:
For safety reasons, the controller switches off
operation after a period of 6 hours. Resetting is only
possible with the operating switch.
To activate the humidity controller you have to turn
the switch (1) to „ON". The required humidity can be
set from 10 - 100% with the rotary regulator (2).
Note: The actual humidity in the cabin depends on
the size and density of the sauna cabin and therefore
has to be determined by experiment.
Fast-select button (4)
This function serves to prevent oversaturation with
scented essences during a sauna
session. To get full enjoyment from scented
essences we recommend
activating the short-run button „K" before entering the
sauna (approx. 15 minutes ON time).
Important!
Use only those fragrances and scented essences
stipulated by the
manufacturer.
Important safety information:
Mis-use may harm your health!
Be sure to observe the doses stipulated!
Function
Control system ready
Evaporator working
6 hours safety cut-out