Important Safeguards - Alecto BW-700 Mode D'emploi

GB
The final temperature of the milk or food is determined by the amount of water in
the bottle warmer. If the temperature is too high, it is recommended to use less
water in the bottle warmer. In case the temperature is too low, use more water.
It is advised to regularly take out the bottle or pot and shake or stir well for an
even heating of the content.
• Read and save these instructions.
• Never use the unit without water in it.
• Do not move an appliance containing hot liquids.
• Do not immerse appliance, cord or plugs in water or other liquid.
• Place the Baby Bottle Warmer out of the reach of children and on a dry, non-
slip, horizontal surface.
• Close supervision is necessary when the unit is used near children.
• Do not let cord hang over edge of table or counter.
• Do not place on hot surfaces or in a heated oven.
• Only use the Baby Bottle Warmer when the ambient temperature is between
+7ºC and +37ºC.
• Change the water in the bottle warmer each time after use for hygienic
reasons.
• Watch out for hot water splashes when the water is boiling. For protection,
place the steam cover on the bottle warmer.
To quickly warm up:
1. Place the bottle warmer on a stable surface, out of reach of children.
2. Pour 50ml of water into the bottle warmer.
3. Place the jar (without lid) or bottle into the bottle warmer.
4. Insert the plug into a 230Volts wall socket.
5. Press the
6. Now within 5 seconds, use the M button to select:
use the
the recommended warm-up time, see the next
page
7. 5 seconds after making your selection the heating
element of the bottle warmer will switch on while
the display starts counting down to 0.
8. When the countdown reaches 0:00, the display starts flashing for 1 minute.
During this minute, leave the jar or bottle in the warm water.
IMPORTANT USER TIPS

IMPORTANT SAFEGUARDS

button to switch on the bottle warmer.
or button to increase or decrease
OPERATION
16