Publicité
PICTURE 8
THE DEPTH OF THE CUT IS THE DISTANCE BETWEEN
THE FOOT OF YOUR SAW AND THE HIGHEST POINT
LOCATED ON THE SAW BLADE. THE DEPTH OF YOUR
SAW CUTTING CAN BE AJUSTED BY A LEVEL
LOCATED ON THE SIDE OF YOUR SAW (PICTURE 8).
AJUSTING THE CUTTING ANGLE BETWEEN 0 – 45
DEGREES.
PICTURE 9
THE LEVER THAT LOCKS THE CUTTING ANGLE
BETWEEN 0 – 45 DEGREES IS LOCATED AT THE
FRONT OF THE YOUR SAW (PICTURE 9). AJUST THE
CUTTING ANGLE BY USING THE SCALE IN DEGREE
WHICH IS ALSO LOCATED AT THE FRONT OF THE SAW.
TWO NOTCHES THAT IDENTIFY 45 ET 90 DEGREES
ARE USED AS A GUIDE TO INDICATE THE LOCATION
OF THE BLADE RELATIVE TO THE CUTTING POSITION.
PARALLEL CUT
PICTURE 10
YOUR SAW POSSESSES A PARALLEL GUIDE LOCATED
AT THE FRONT OF TOOL. THE GUIDE IS FIXED BY
USING THE LEVEL (PICTURE 10).
PRECAUTION TO BE TAKEN WHEN YOU REPLACE
SAW BLADE
CHECK IF YOUR SAW IS DISCONNECTED FROM
Ref.: 647062
THE POWER SOURCE AND THE EXISTING
BLADE IS MOTIONLESS.
TURN THE LOWER GUARD TO PUT IT IN AN
OPEN
POSITION.
POSITION OF THE LOWER GUARD WITH A
SCREWDRIVER OR A PIECE OF WOOD.
PRESS THE LOCK BUTTON AND TURN THE
HEXAGONAL SCREW WITH THE HEXAGONAL
WRENCH THAT COMES WITH YOUR SAW
ANTI-CLOCKWISE (PICTURES 12 ET 13).
PICTURE 12
PICTURE 13
TAKE OUT THIS SCREW AND THE LOWER
GUARD. AFTER THIS OPERATION, YOU CAN
TAKE OUT THE BLADE WHICH IS SHARP. THUS,
HANDLE THE BLADE WITH CAUTION TO AVOID
ANY RISK OF BEING INJURED.
NOTICE THE LOCATION OF THE LOWER GUARD.
IF THE LOWER GUARD DROPS, IT MUST BE PUT
IN PLACE (PICTURE 13).
PICTURE 13
BEFORE REPLACING A NEW BLADE, REMOVE
ALL THE DEBRIS PRESENT IN THE UPPER AND
LOWER
GUARDS,
INSTANCE.
MAKE SURE THAT SAW TEETH AND ARROW ON
THE
NEW
BLADE
DIRECTION AS THE ARROW PRINTED ON THE
LOWER GUARD.
TIGHTEN THE HEXAGONAL SCREW
NOTE: FOR SECURITY PURPOSE, VERIFY BEFORE,
DURING AND AFTER THE CUT, IF THE HEXAGONAL
SCREW IS WELL TIGHTENED.
RELEASE THE LOWER GUARD BY REMOVING
12
MAINTAIN
THIS
OPEN
USING
A
BRUSH
FOR
POINT
IN
THE
SAME
Publicité
