JAROLIFT TDRC01 Mode D'emploi page 18

PROGRAMMING
Add / copy handheld transmitter - TDRC01
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the receiver!
HINWEIS:
The TDEF radio motors and the external TDR receivers can be operated with several hand-held and wall-mounted transmitters.
can be controlled. This enables e.g. individual control of the motor with a TDRC01 as well as
Simultaneous group and time control with another hand-held or wall-mounted transmitter with
Timer function (e.g. TDRCT04).
For details, please refer to the respective instructions for the TDEF radio motors and TDR radio receivers.
To teach-in additional hand-held or wall transmitters to a radio motor or radio receiver, you need a hand-held or wall transmit-
ter that has already been taught-in (see "Initial programming").
Programming example - Adding a TDRC04
1. On a transmitter that has already been taught in, press the UP and DOWN Key simultaneously.
2. Then press - also on the already taught-in transmitter - 8x the STOP-Key.
3. The motor will vibrate briefly to confirm.
4. Press within 10 seconds at the new transmitter to be taught in at the same time the UP and DOWN Key .
5. Then briefly press the STOP button on the transmitter to be retrained. The motor will vibrate again briefly to confirm. The
code has been copied to the new transmitter.
Transmitter already taught-in:
Up/down
button simul-
taneously
press.
New transmitter to be taught:
Select the
desired chan-
nel (1-4) via
the channel
selection
button.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
18
8 x stop button
Press (max. 10
sec.).
max. 10 Sek.
Up/down
button si-
multaneous-
max. 10 sec
ly press.
(engine vibrates)
Stop button
press.
max. 10 sec
max. 10 sec.
(engine vibrates)