Data Clearing; Pointing The Sensor To The South; Moon Phases - Bresser Weather Center 5in1 Comfort Mode D'emploi

19 Data clearing

During installation of the outdoor sensor, the sensor could have been triggered, resulting in erroneous
rainfall and wind measurements. After the installation user may clear all the erroneous data from the
main unit without a need to reset the clock and re-establish pairing. Simply press and hold the HIS-
TORY button for 10 seconds. This will clear out any data recorded before.

20 Pointing the sensor to the south

The sensor is calibrated to be pointing to North by default. However, in some cases, users may wish
to install the product with the arrow pointing towards the South, especially for people living in the
Southern hemisphere (e.g. Australia, New Zealand).
1
1 Northern hemisphere
1. First install the outdoor sensor with its arrow pointing to the south. Please refer to "Installation"
chapter for mounting details.
2. Press and hold the WIND button for approx. 8 seconds until the upper part (northern hemisphere)
of the compass rose is blinking.
3. Press the UP or DOWN button to change to lower part (southern hemisphere).
4. Press the WIND button to confirm and exit.
Note:
Changing the hempisphere setting will automatically switch the direction of the moon phase on the dis-
play.

21 Moon phases

In the Northern hemisphere, the moon waxes from the right. Hence the sun-lit area of the moon moves
from right to left in the Northern hemisphere, while in the Southern hemisphere, it moves from left to
right. Below are the 2 tables which illustrate how the moon will appear on the main unit.
36 / 68
2
2 Southern hemisphere