Changing The Battery; Types Of Fault - Facom CL3.CTB50 Notice Originale

To access it, fi rst remove the tool's protection ring, as shown in the photo above.
To remove the bush:
1. Press the locking pin using a screwdriver while pulling the ring with your thumb.
Use preferably a Torx screwdriver or any other round bit.
2. Repeat the same operation on the locking pin on the other side. The ring must be completely released
and can be removed.
7. ENERGY LEVEL AND DISPLAY
7.1 CHARGE MANAGEMENT
To save on the energy consumed on the battery, when left idle for more than 5 minutes, the tool switches to the
standby mode. The indication lamp switches off.
The tool is reactivated when the trigger is pressed again.
If left unused for a long period, we recommend to remove the battery to avoid damaging it.
When the tool is used, the indicator on the top of the tool indicates the battery's charge level.
The indicator status table is shown below:
Color Mode
Steady green Operational
Steady orange Warning
Steady red Discharged

7.2 CHANGING THE BATTERY

Refer to paragraph 4: Battery insertion/removal
1. Release the battery clip.
2. Remove the battery using the tab.
3. Insert a charged battery in the compartment instead of the discharged one.
4. The tab must be oriented towards the top of the clamp.
5. Release the clip.
8. TROUBLESHOOTING AND MAINTENANCE

8.1 TYPES OF FAULT

The indicator lamp also indicates the tool's potential malfunctions and safety modes.
NU-CL3.CTB50 - CL3.CTB120_0216.indd 17
Pin of
locking
Description
The clamp is in the operating state with a suffi cient battery level.
The battery has dropped to 30% capacity. Its charging or its
replacement will be required very soon.
The battery is in the critical zone (<10%) and requires to be charged
immediately. The clamp is no longer able to clamp the fl anges.
A new battery must be installed.
17
2/9/2016 4:25:29 PM