Product Features - Jimmy F2 Mode D'emploi

Please install the nozzle under the switch-off status, do not assemble or disassemble the nozzle
during using to avoid scald. After using, reassemble it until the nozzle cool down to avoid scald.
Please keep the distance of more than 10cm between hair and inlet, to avoid hair from
entangling into the hair dryer. Please keep the distance of more than 3cm between hair and
outlet to avoid scald.
After using, turn off the hair dryer and unplug the power cord plug.

Product features

This hair dryer uses Nano water ion and negative ion technology to deeply replenish hair, remove
frizz, care for damaged hair, help reduce static electricity accumulation in the hair, and help
tighten hair scales, making the hair more healthy and shiny.
Nano water ions are created by water decomposition under high electricity voltage, the ions are
wrapped by water.
During using, the air includes Nano water ions in both hot and cool wind mode.
In the process of generating Nano water ions, this hair dryer may have the following conditions,
which are normal:
1.There is water drop out from the water ion nozzle.
2.It might have some special smell, which will not cause harm to the human body.
The water ion hair drying will have no obvious effect for the following people:
• people with natural curly hair
• People with easily curled hair
• People with good hair quality
• People with short hair
The Nano water ions is generated through accumulating the water in the air, but under some
circumstances, due to limited restrictions, it might not generate water ions, it will generate
negative ions instead.
Daily maintenance and storage
Please make sure the power button is in the off position and then unplug the socket during
cleaning.
Please regularly use the towel, cotton bud or tooth brush to clean the air inlet and outlet and
remove the foreign objects attached on the mesh of back cover.
Please do not use nail or sharp articles to press and rub the air inlet and outlet to avoid products
damage.
Please do not use alcohol, nail polish remover, detergent or napkin with alcohol to clean the
product, otherwise, it will cause failure, crack or colour fading.
4