Removing The Side Panels; Installing The Motherboard; Installing Pci-E/Pci Card(S); Installing The Power Supply - Corsair CARBIDE Série Guide D'installation

CARBIDE SERIES
®

1. Removing the Side Panels

Simply remove the
thumbscrews then slide the
side panels back and out.
Note: Corsair recommends
removing both side panels and
setting them aside when building
your system to avoid accidental
damage. Both side panels are
interchangeable and should be
removed to reduce clutter.

2. Installing the Motherboard

First, install your
motherboard's I/O shield
(see your motherboard's
SPEC-M2 STEP1
manual for guidance).
Align your motherboard with
the pre-installed standoffs.
Use the provided screws
b
to secure the
motherboard to the
motherboard tray.
9
SPEC-M2
SPEC-M2 Step 3

3. Installing PCI-E/PCI Card(s)

Remove slot cover, install
expansion card, and secure
with screw(s) as necessary.

4. Installing the Power Supply

Position the PSU on the
bottom of the case then align
the case holes and secure the
PSU with screws provided with
your power supply.
10