Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Steam Ironing
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity regulator (4).
Steam Jet
•
Turn the button (5) to the steam jet symbol.
•
Then press the button (5) for the steam jet.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Note: To avoid excess water leaking from the soleplate do not operate the steam
burst for more than 5 seconds without interruption.
When ironing at low temperatures, make sure that you reduce the quantity of
steam or iron without steam. If the temperature is too low water may leak from the
soleplate.
Refi lling the water tank
•
Always disconnect the mains plug before refi lling water.
•
Set the steam control (4) to "
and carefully pour in the water. Do not exceed the maximum line as marked on
the water reservoir.
Spray Function
•
Turn the button (5) to the spray symbol.
•
In order to moisten a section to be ironed press the spray button (5).
•
Always remove the mains lead before cleaning!
•
Clean the casing with a slightly damp cloth.
•
Clean the iron with a slightly humid cloth.
•
Always return the steam regulator to the „
the water tank in order to prevent any leaks.
40
05-DB 2988 40
no steam
Small steam volume
Large steam volume
Caution: the steam is hot. Danger of scalding!
" (no steam). Open the lid of the refi ll inlet (6)
Cleaning and Storage
" position after use and empty
24.05.2005, 11:15:21 Uhr
Publicité
Table des Matières
