Installation Principle - weltico 63506 Notice D'installation Et D'utilisation

1.2 - Installation principle.

1) The TOROIDAL transformer must comply to supply one or several bulbs with power.
2) THE CONTROLLER-MODULATOR MUST BE PLUGGED INTO THE 12 VAC
POWER GRID ON THE SECONDARY SIDE OF THE TRANSFORMER THAT
SUPPLIES THE BULBS.
It is advisable to install it alongside the 230 Vac/12 Vac toroidal transformer and away from
any metallic part that could harm the controller's quality of reception.
TRANSFORMER
230 Vac
3) Install the controller-modulator in a place sheltered from corrosive media and rain.
4) Learning of the synchronisation between the controller and the remote control.
- The training consists in the controller recognising the remote control to use to
change the colours or programmes for your bulbs.
4a) Unscrew the four screws and remove the lid from the controller.
4b) Power up the transformer to feed the controller and the bulb(s).
4c) You have 30 seconds to initialise the remote control:
Press the "PROGRAM" buttons of the remote control at the same time, the remote
control's indicator light comes on then switches off once the synchronisation has
finished. Release the buttons.
4d) Do a test by turning off the bulb(s) by pressing the "OFF" button of the emote
control then putting the light back on by pressing one of the "COLOR" or
"PROGRAM" buttons.
5) Do range tests with the remote control to define its ideal location.
6) Fix the controller permanently on its wall following the instructions below.
6a) - Drill 4 holes in the wall then peg (centre distance: 60 mm/104 mm.
6b) – Fix the controller to the wall then close the lid with the screws.
12 Vac
CONTROLLER-MODULATOR
Bulb 1
EN
Bulb 2
Bulb 3
Page : 8