Aleratec Charge and Sync Station 16 Guide De Démarrage Rapide page 6

Using the Charge and Sync Station 16
Connection -•Continued
3. If syncing, use the USB A to B cable provided and connect the USB B
end on the unit. Connect the USB A end to your host computer. Unplug
the USB cable if charging your devices.
Sync times will vary greatly depending on a variety of factors
including, but not limited to, your computer and the amount of data
being synced.
Please note that this station only serves as a pathway for
communication between your devices and the computer. Actual
management and synchronization is handled by software or apps
independent of this station.
After syncing, eject each device properly from the computer before
disconnecting or powering off.
4 www.aleratec.com