Fermax CITYLINE VDS-BUS2 Manuel D'installation page 12

VDS-BUS2 Programming
VDS-BUS2 Programming
3. Assign the new addresses to each button:
3.1. Activate the auto-start option on the monitor.
3.2 Press the call button associated with this monitor (residences) on
the entry panel.
The call code previously programmed on that monitor will be
assigned to the button (it will be stored on the amplifier).
Repeat step 3 with all the monitors-buttons on the system.
4. Exit programming mode:
Press the SW1 amplifier's «button programming» button again
The amplifier automatically exits programming mode following 5 minutes of
inactivity.
2. Sequential Programming.
This mapping programming mode allows call codes (addresses) be assigned
sequentially in whatever order you require.
The steps to be followed are detailed below:
1. Select the «sequential button programming» mode on the amplifier:
Press the SW1 button and hold for 5 seconds (a characteristic 3«beep»
tone will be emitted from the speakers).
2. Assign the new addresses to each button:
Press the call buttons in whatever order you wish to assign the codes on
the entry panel, starting with 1, and running sequentially upward.
The amplifier stores each buttons' new call codes.
3. Exit programming mode:
Press the SW1 amplifier's «button programming» button again
The amplifier automatically exits programming mode following 5 minutes of
inactivity.
Pag 12
VDS-BUS2 Programming
VDS-BUS2 Programming
3. Assign the new addresses to each button:
3.1. Activate the auto-start option on the monitor.
3.2 Press the call button associated with this monitor (residences) on
the entry panel.
The call code previously programmed on that monitor will be
assigned to the button (it will be stored on the amplifier).
Repeat step 3 with all the monitors-buttons on the system.
4. Exit programming mode:
Press the SW1 amplifier's «button programming» button again
The amplifier automatically exits programming mode following 5 minutes of
inactivity.
2. Sequential Programming.
This mapping programming mode allows call codes (addresses) be assigned
sequentially in whatever order you require.
The steps to be followed are detailed below:
1. Select the «sequential button programming» mode on the amplifier:
Press the SW1 button and hold for 5 seconds (a characteristic 3«beep»
tone will be emitted from the speakers).
2. Assign the new addresses to each button:
Press the call buttons in whatever order you wish to assign the codes on
the entry panel, starting with 1, and running sequentially upward.
The amplifier stores each buttons' new call codes.
3. Exit programming mode:
Press the SW1 amplifier's «button programming» button again
The amplifier automatically exits programming mode following 5 minutes of
inactivity.
Pag 12