How To Change The Battery - pico Technology Mixmaster Manuel D'utilisation

Pico Technology
Example waveforms
When you have have captured your first waveform, your PicoScope Automotive
display should look something like this:
The top waveform is the Bank A parade, and the bottom waveform is the Bank B
parade. As this is a wasted spark ignition system, both banks fire at the same
time.
2.6

How to change the battery

When the red low battery indicator lights up, the battery is low and should be
replaced. To replace the battery, follow these steps:
 Disconnect all input, output and ground leads from the Mixmaster.
 Set the Mixmaster's power switch to OFF.
 Remove the shock-resistant rubber case.
 Open the battery cover on the underside of the unit by sliding it in the direction
of the arrow.
 Replace the battery, taking care to connect the new battery the right way
round.
 Replace the battery cover.
 Replace the rubber case, making sure that the hinged stand opens towards the
bottom of the unit.
 Set the power switch to ON. Check that the power light is now on and the low
battery light is off. ■
DO120-3
Mixmaster User's Guide
9