First Time Use - iStorage DISKASHUR M2 Guide De Démarrage Rapide

First Time Use

PIN Requirement:
• PINs must be a minimum length of 7 and maximum 15 digits.
• Cannot contain all sequential numbers (2345678 or 9876543).
• Cannot contain all repeating numbers (1111111).
• The SHIFT key can be used for additional combinations (e.g. SHIFT+1 is a separate
value to just 1).
To configure a 7-15 digit Admin PIN and unlock the diskAshur M
follow the simple steps in the table below.
Instructions - First Time Use
1. Connect the diskAshur M
a powered USB port on your
computer
2. Press and hold down both
KEY ( ) + 1 buttons
3. Enter a New Admin PIN (7-15
digits) and press the KEY ( )
button once
4. Re-enter your New Admin
PIN and press the KEY ( )
button again
Locking the diskAshur M
To lock the drive, safely eject the diskAshur M
unplug from the USB port. If data is being written to the drive, unplugging the diskAshur M
will result in incomplete data transfer and possible data corruption.
4
LED
to
2
2
from your host operating system and then
2
for the first time, please
2
LED State
RED, GREEN and BLUE
once in sequence then the
LED blinks twice and finally switches
to solid RED and GREEN
indicating the drive is in the Initial
Shipment State
LEDs turn to blinking GREEN
solid BLUE
Blinking GREEN and solid
LEDs switch to a GREEN
back to Blinking GREEN
BLUE LEDs
BLUE LED rapidly blinks then
switches to a solid BLUE
and finally to a solid GREEN
indicating the Admin PIN has been
successfully configured and drive
unlocked
LEDs blink
GREEN
LEDs
and
BLUE
blink then
and solid
LED
LED
2