Garmin BC 20 Instructions D'installation page 4

You may want to position the vehicle in the center of a
parking stall, and then pull forward into the next stall. This
allows you to use the parking stall lines in the rear of the
vehicle as reference points for alignment.
The curb, driveway, or parking stall lines should be clearly
visible on the device.
2
From the camera view, select
3
Use the arrows in the corners of the screen to move the
guidance lines to match the angle and position of the curb,
driveway, or parking stall lines.
The guidance lines should appear directly on top of your
reference points.
4
Use the arrows in the center of the screen to move the
guidance lines up or down.
The red section of the guidance lines should be aligned with
the rear of your vehicle.
5
If necessary, reposition the vehicle with the other side closely
aligned to a curb, driveway, or parking stall lines, and repeat
the alignment process.
You should attempt to keep the guidance lines symmetrical,
even if your vehicle is not in perfect alignment with the curb,
driveway, or parking stall lines.
6
Select when alignment is complete.
Showing or Hiding Guidance Lines
1
Select .
2
Select an option:
• To show the guidance lines on the screen, select Show
Lines.
• To hide the guidance lines on the screen, select Hide
Lines.
Restoring Alignment
You can reset the guidance lines to their default settings.
1
Select > Restore.
2
Select Yes.
Pairing the Transmitter and Device Mount
The transmitter and wireless camera PND mount come paired
from the factory. If the transmitter and the PND mount are
properly installed and you are not receiving video, you can try to
re-pair the transmitter and the PND mount.
1
Verify there is no power to the transmitter by placing the
vehicle in park or turning off the applicable steady power
source.
2
Turn on the PND device connected to the wireless camera
PND mount.
3
On the wireless camera PND mount, hold PAIR until Start
Pairing appears on the PND device.
If Start Pairing does not appear on the PND device, make
sure the wireless camera PND mount is correctly connected
to power.
4
Apply power to the transmitter by placing the vehicle in
reverse or turning on the applicable steady power source.
After approximately five seconds, Pairing OK appears on the
PND device.
4
> Adjust.
5
Power cycle both the wireless camera PND mount and the
transmitter by turning them both off and then back on again.
6 If the transmitter and wireless camera PND device mount do
not pair successfully, repeat steps 1–4.
Specifications
Specification
Camera sensor
Camera resolution
Camera angle (vertical)
Camera angle (horizontal)
Camera and transmitter input voltage
Fuse
Camera and transmitter current usage
Camera and transmitter waterproof rating
Camera temperature range
Transmitter and PND mount temperature
range
Wireless transmission type
Wireless transmission distance
Value
1/3.7-type CMOS
640 × 480
115°
140°
9–28 VDC
500 mA, fast-blow
150 mA @ 12 VDC
IEC 60529 IPX7
-40° to 85°C (-40° to 185°F)
-20° to 70°C (-4° to 158°F)
2.4 GHz ISM radio band
10 m (30 ft.)
Installation Instructions