Power Supply; Headset Operation; Switching The Headset Off; Logging The Headset Onto The Base Station - freeVoice Fox FX 840 DECT USB Manuel D'utilisation

E

Power supply

Plug the mains lead into the marked socket on the base of the headset.
Plug the mains adapter into a 220-volt socket.
The battery symbol will start flashing (white).

Headset operation

Switching the headset on
Press the «Call acceptance» key briefly on the headset, the blue LED on the headset comes on for
2 sec.

Switching the headset off

Press and hold down the «Call acceptance» key on the headset until the blue LED starts to flash
rapidly. Then release the key; the headset switches off.
Logging the headset on the base station
Lift the headset from the base station and switch it offl ine (by pressing the call acceptance key so
that no blue online symbol lights up on the base station)
Press the pairing key on the rear of the base station until the blue online symbol lights up, then
release the key. The online symbol starts to fl ash.
Press the mute key on the headset until the online symbol on the base station goes out; the headset
is now connected to the base station.
If pairing has not been successful after 2 min, the pairing mode is terminated by the headset and base
station. Pairing then has to be repeated.
17