Green Cell POWER PROOF 600VA Mode D'emploi page 3

and compact dimensions make it an ideal solution in the office or at home when the workplace is very
limited. The UPS uses Line Interactive and AVR technologies to protect your equipment and enable
operation over a wide range of input voltages. Key Features of PowerProof UPS Devices:
• advanced controls guarantee high switching speed and operational safety;
• AVR technology makes your devices up to 15% resistant to mains voltage fluctuations;
• Green Power function for energy saving;
• Cold start function;
• automatic switching after restoration of the power supply;
• compact size, light weight;
• Overload protection.
BASIC FUNCTIONS OF THE GREEN CELL UPS
1. Device
After removing it from the packaging, make sure that no damage in transit is visible on the case of the
device. If you notice any damage, do not connect the device and contact the seller.
2. Charging
The device leaves the factory with fully charged batteries. However, due to the self-discharge phenome-
non, it may be necessary to charge it after receiving. Switch on the device and connect it to the mains.
Leave the UPS for about 6 hours without load to fully charge it.
3. Location
The device should be used under controlled conditions to ensure adequate airflow. Be sure to avoid:
large pollutants (dust, sand, etc.),
Humidity,
Corrosion sources
high temperatures.
At the same time, make sure the UPS is not near the computer monitors to avoid interference.
4. Connection
Connect the PowerProof power supply to a bipolar socket with ground pin. Then you can connect the
computer and other devices to the output jacks. ATTENTION! Do not connect devices via extension cords
or distributors.
5. Commissioning
To start the device, press the POWER button on the front of the case.
To turn off the UPS, press the button again.
6. cold start
Press the POWER button to force the battery to work.
EN