Maintenance And Storage - Stiga 100 COMBI 3 Manuel D'utilisation

(Translation of the Original Instructions)
moving parts have come to a complete
stop):
a. Before refuelling;
b. Every time you remove the grass collector
sack or put it back on;
c. adjusting the cutting height, assuming this
operation cannot be done from the driver's
seat.
Disengage the cutting blade or the PTO
during transport or whenever the ma-
chine is not being used.
Reduce the throttle setting before stop-
ping the engine. turn the fuel off at the
conclusion of mowing, following the in-
structions in the manual.
Take care with multiple blade cutting
decks as one rotating blade may cause
other blades to rotate.
WARNING - In the event of failures or
accidents when working with the ma-
chine, stop the engine immediately
and move the machine away to avoid
causing further damage; in the event of
accidents with injuries to operators or
third parties, take the first aid measures
which are most appropriate to deal with
the situation and contact a health care
facility for the necessary treatment.
Carefully remove any debris which
could cause damage or injury to per-
sons or animals if ignored.
The noise and vibration levels shown
in these instructions are the maximum
levels for use of the machine. The use
of an unbalanced cutting element, the
excessive speed of movement, or the
absence of maintenance have a signifi-
cant influence on noise emissions and
vibrations. Consequently, it is necessa-
ry to take preventive steps to eliminate
possible damage due to high levels of
noise and stress from vibration. Main-
tain the machine well, wear ear protec-
tion devices.
3.4

MAINTENANCE AND STORAGE

CAUTION! - Before cleaning or doing
maintenance work, take out the ignition
key and read the relevant instructions.
Wear adequate clothing and work glo-
ves whenever your hands are at risk.
ENGLISH
CAUTION! - Never use the machine with
worn or damaged parts. Faulty or worn-
out parts must always be replaced and
never repaired. Only use original spa-
re parts: The use or non-original and/
or incorrectly fitted parts will compro-
mise the safety of the machine, may
cause accidents or personal injuries
for which the Manufacturer is under no
circumstance liable or responsible.
Any regulations and maintenance ope-
rations not described herein must be
carried out by your Dealer or Authori-
zed Service Centre, which have the ne-
cessary knowledge and equipment to
ensure that the work is carried out cor-
rectly, maintaining the correct degree of
safety and the original operating condi-
tions of the machine. Any adjustments
or maintenance operations carried out
by people not having the necessary
knowledge will nullify the warranty and
exonerate the manufacturer from all lia-
bility.
• After each use of the machine, remove the key
and check for any damage.
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
Regular maintenance is essential for safety and
for maintaining performance levels.
• Regularly check that the cutting deck blade
screws are securely tightened.
Wear
handling the cutter blade assy during
removal and reinstallation operations.
Check the cutting blade's balance after
sharpening. All operations concerning
the cutting deck assy (disassembling,
sharpening, balancing,
and/or replacement) are tough works
and require a specific knowledge as
well as special tools; for sake of safety,
they should always be performed by an
authorized service centre.
• Regularly check the brakes work properly. It is
important to service the brakes and repair them
if necessary.
• Replace any damaged warning and instruction
stickers.
suitable work gloves
EN
when
assembling
7