Inserting And Charging The Battery - Velleman BTSP1 Notice D'emploi

4. Overview
Refer to the illustrations on page 2 of this manual.
1
speaker
2
microphone
3 LED
4
5-pin USB charging socket
5.

Inserting and Charging the Battery

Refer to the illustrations on page 2 of this manual (A – E).
• Prior to using the speakerphone, it is recommended to charge the battery fully
for the first time. Normal full charge time is approximately three hours.
• Insert the battery as illustrated. Connect the car adapter plug to the
speakerphone using the included cable. Insert the car adapter plug into a 12V
outlet.
• Charging indication will be delayed for a few minutes if the speakerphone has
not been used for a long time or if the battery is drained.
• To prolong durability of the battery, it is recommended to charge the
speakerphone whenever low battery is encountered. The red LED will flash every
three seconds. The battery's life will be decreased if the speakerphone is
constantly being used under low battery condition.
6. Use
Switching On/Off Your Speakerphone
• Switch on the speakerphone by pressing and holding the MF button for ±4
seconds until you hear a short beep. The blue LED will flash 5 times.
• Switch off the speakerphone by pressing and holding the MF button for ±4
seconds until you hear a short beep. The red LED will flash 5 times.
Pairing Your Speakerphone
• Place the speakerphone and mobile handset no more than one meter apart.
Ensure the speakerphone is switched off.
• Press and hold the MF button for 6 seconds until. The LED flashes red and blue
alternatively. Your speakerphone is now ready for pairing.
• Activate the Bluetooth
accessible Bluetooth
details.
• Select BT speaker form the list.
• Enter the pre-programmed code 0000 and press OK to pair the speakerphone
and the handset. When pairing is completed, the blue LED will flash every 3
seconds. The speakerphone is now in standby mode.
• Install your speakerphone (Refer to the illustrations on page 2).
NOTE: If the pairing is not completed within two minutes after the pairing mode
has been activated, press and hold the MF button again for 6 seconds.
31.01.2011
BTSP1
5
6
7
8
®
function on your mobile handset and search for
®
devices by referring to your mobile handset user guide for
MODE button
MF button (multi-function button)
volume increase (V+)
volume decrease (V-)
4
Rev. 06
©Velleman nv