Adjustment Of The Spring Tension; Maintenance And Care - Conductix-Wampfler 040460-06x12 Instructions D'utilisation

Operating Instructions
Hose Reel
040460-...
5

Adjustment of the spring tension

•
Pull-off the hose approx. 1-2 turns from the reel and stop the drum.
•
Remove the hose reel guidance (Pos. 50).
To increase the spring tension
•
According to the required spring tension, coil-up manually 1-2 layers of the hose on the drum.
To reduce the spring tension
•
According to the required spring tension, wind-off manually 1-2 layers of the hose from the drum.
•
Reinstall the hose reel guidance (Pos. 50).
Caution After having increased the spring tension, it must be checked if the hose can be winded off completely:
the spring must not reach the lock to avoid an over stretching.
Advice
The reel cannot be released anymore, if the hose cannot be completely extracted and the stop snaps in simultaneously.
To remedy:
- hold the drum tight,
- by means of a screwdriver shortly lift the greed level (Pos. 190) to release the lock,
- now, reduce the spring force (refer to "To reduce the spring tension").
6

Maintenance and care

The spiral flat spring
No special maintenance is required on the spiral flat spring. If after a while a release is observable, the spring tension has to be
readjusted (refer to "Adjustment of the spring tension").
The axis with ball bearings
No special maintenance is required on the axis with ball bearings.
The hose
Every hose may burst because of outer damages and/or because of ageing. In order to prevent eventual damages due to abnormal
flow out of fluid or gas, the wear of the hose should be checked regularly.
If necessary the hose should be changed!
BAL0400-0060b-D/E/F
www.conductix.com Seite 14 von 25