Technical Specifications - Henry Schein Hs-Tray Cure Manuel D'utilisation

2
1-. Connect unit to a 220 ~ 230 Volts/50 Hz. (or 110Volt 50/60Hz on option) power outlet
fitted with an earth terminal
To turn on unit, press the switch-button located at rear.
2-.
to start, press the power switch located at the back of the unit.
A 3 minute Pre-set curing cycle will be shown on the display; the curing time can be
3-.
adjusted according to the polymerization required for composite or resin based materials.
in options according to the polymerization required for composite or resin based mate-
rials.
TO re-set curing cycle from 0.1(6seconds) to 99minutes:
-Press L key to increase curing time up to 99 minutes
-Press M key to decrease curing time down to 6seconds ( "0.1" shown on the display)
*The re-set curing time can be fixed and memorized before opening the chamber door
or before turning off the unit.
4-.
Press the START/STOP switch to begin the polymerization cycle.
to interrupt cycle, pull the chamber door open and the polymerisation will stop auto-
matically for safety. The display will be flash " – 0 " .
The programmed time remains in the memory. Press START/STOP switch to repeat the
5-.
cycle .

TECHNICAL SPECIFICATIONS:

AC SUPPLY
FML LAMP -BLUE
LAMP LIFE
CONSUMPTED POWER : < 30W
WEIGHT
UNIT OVERALL SIZE
Item code
Contact to your supplier or distributor for further service and technical information.
HS-T
Light Curing Unit For Dental Laboratory
: 230V 50/60Hz (110 Volts/60Hz available on request)
: 27W/0.610A/460 lm
: 5,000 Hours
: 2.1 KGS
: 8.8cm(H)x13.5cm(W)x26m(D) cm
: 900-2691
RAY
I I N N S S T T R R U U C C T T I I O O N N F F O O R R U U S S E E
C
URE