Installing And Operating Your Fridge - ROMMER FV 250 A+ Guide D'utilisation

• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes
immediately after you have taken them out of the ice-making compartment.
• Do not re-freeze frozen goods after they have melted. This may cause health
issues such as food poisoning.
• Do not cover the body or top of fridge with lace. This affects the
performance of your fridge.
• Secure any accessories in the fridge during transportation to prevent
damage to the accessories.

Installing and operating your fridge

Before starting to use your fridge, you should pay attention to the following points:
• The operating voltage for your fridge is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded
usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves,
gas ovens and heater cores, and at least 5 cm away from
electrical ovens.
• Your fridge should never be used outdoors or exposed to rain.
• When your fridge is placed next to a deep freezer, there should
be at least 2 cm between them to prevent humidity forming
on the outer surface.
• Do not place anything on your fridge, and install your fridge in a suitable place so
that at least 15 cm of free space is available above it.
• Use the adjustable front legs to make sure your appliance is level and stable.
You can adjust the legs by turning them in either direction. This should be done
before placing food in the fridge.
• Before using your fridge, wipe all parts with a solution of warm water and a
teaspoon of sodium bicarbonate, then rinse with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at the
rear) by turning it 90° (as shown in the figure) to prevent the con-
denser from touching the wall.
• The refrigerator should be placed against a wall with a free space
not exceeding 75 mm.
EN - 5 -