Before Using Your Fridge; Installing And Operating Your Fridge - ROMMER FL185NF A++ Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing and operating your fridge

Before starting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• Before using your fridge, please call the nearest authorised service for help with the
installation, operation and usage of your fridge.
• W e do not accept responsibility for any damages that occur due to ungrounded
usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater
cores, and at least 5 cm away from electrical ovens.
• Your fridge should never be used outdoors or exposed to rain.
• When your fridge is placed next to a deep freezer, there should be
at least 2 cm between them to prevent humidity forming on the
outer surface.
• Do not place heavy items on the appliance.
• Do not place anything on your fridge, and install your fridge in a
suitable place so that at least 15 cm of free space is available
above it.
• If you will place your fridge next to your kitchen cabinets, leave a space of 2 cm
between them.
• Install the plastic distance guide (the part with black vanes at the
rear) by turning it 90° (as shown in the figure) to prevent the
condenser from touching the wall.
• The refrigerator should be placed against a wall with a free space
not exceeding 75 mm.
• Use the adjustable front legs to make sure your appliance is level
and stable. You can adjust the legs by turning them in either direction. This should
be done before placing food in the fridge.
• Before using your fridge, wipe all parts with a solution of warm water and a teaspoon
of sodium bicarbonate, then rinse with clean water anddry. Place all parts in the
fridge after cleaning.
• Do not use plug adapter

Before using your fridge

• When using your fridge for the first time, or after transportation, keep
it in an upright position for at least 3 hours before plugging into the
mains. This allows efficient operation and prevents damage to the
compressor.
• Your fridge may have a smell when it is operated for the first time.
This is normal and the smell will fade away when your fridge starts
to cool.
EN - 5 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fl186nf a++ inox

Table des Matières