Installation Instructions; Ball Caddy Use Requirements; Unpack The Ball Caddy; Mount The Ball Caddy To Geartrack Channel Or Gearwall Panel For Assembly - Gladiator Garageworks GAWUXXBLTH Instructions D'assemblage

Ball Caddy Use Requirements

Intended to be installed on Gladiator
panel or a GearTrack ® channel.
Maximum weight limit is 25 lbs (11.34 kg) for the ball caddy.

Unpack the Ball Caddy

Remove the ball caddy parts and dispose of/recycle all packaging
materials.
Mount the Ball Caddy to GearTrack
channel or GearWall
IMPORTANT: Be sure the GearWall
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
1. Align the mounting brackets, one on each side of the rear frame,
with the desired slots in the GearWall
channel.
2. Engage the bracket rims into the slots in the GearWall
GearTrack ® channel by lifting up, pushing toward the wall and
lowering the rims into the slots.
A
A. Mounting bracket
3. Inspect the ball caddy from the side to ensure the bracket rims
are fully engaged in the slots.
2

INSTALLATION INSTRUCTIONS

® Garageworks GearWall
®
® panel for Assembly
® panel or GearTrack ® channel is
® ®
panel or GearTrack
®
panel or

Assemble Ball Caddy

® IMPORTANT: Before assembling, first mount the ball caddy to
GearWall ® panel or GearTrack
1. Reach inside the ball caddy and unfasten the fabric closures
running along the bottom front of the caddy.
2. Slide the hollow metal rods onto each end of the lower frame, as
shown.
3. Holding the lower frame where it is joined with the metal rods,
place the frame, bottom edge down, into the ball caddy at an
angle.
B
® channel.
A
A
A. Fabric closures
A
B
A. Hollow metal rod
B. Lower frame
A
C
A. Upper frame
B. Ball caddy front
C. Lower frame