Installation; Wall Installation Using Built-In Outlet Box - Sony AN-820A Mode D'emploi

Installation

Wall installation using built-in outlet box

NO.6-32UNC
screws (supplied)
to the BNC
connector
M3 screw
1) For details, refer to the Operating Instructions for the corresponding device.
2) Use a 50-ohm cable (at least RG-212/U).
Plate covering the outlet box
Hangers
Coaxial cable
Attachment A
(supplied)
Antenna seat
M3 screw (supplied)
No.6-32UNC
screw
Connect to the ANTENNA A/B
IN (DC OUT) connector on
either of the following devices:
• Wireless microphone tuner
1)
• Tuner base unit
1)
• Antenna divider
1)
• Powered mixer
2)
Fit these slots over the
hangers of attachment A.
BNC connector
Place this groove over the
antenna seat of attachment A.
LED (Lights when DC power is
supplied by the connected
device. Lights green when the
gain is 10 dB and lights red when
the gain is 18 dB.)
1)
Installation 5