Important! Before You Start Mowing - Murray ELT125380 CE Manuel D'utilisation

Install The Battery Cables (Figure 7)
WARNING: To prevent sparks, fasten the red cable
to the positive (+) terminal before you connect the
black cable.
1. Remove the protective cap from the battery terminal.
2. Slide the terminal cover (B) onto the red cable (E).
Fasten the red cable (E) to the positive (+) terminal
(D) with the fasteners (F) and (G).
3. Fasten the black cable (H) to the negative (-) terminal
with the fasteners (F) and (G).

Important! Before You Start Mowing

Check the engine oil.
Fill the fuel tank with petrol.
Check the air pressure of the tires.
Check the level of the mower housing.
Attach the battery cables.
8
Check Tire Pressure
Check the air pressure in the tires. Tires with too much air
pressure will cause the unit to ride rough. Also, the wrong
air pressure will keep the mower housing from cutting level.
The correct air pressure is: Front Tires 0,97 BAR (14 PSI),
Rear Tires 0,69 BAR (10 PSI). The tires were over inflated
for shipment.
Prepare The Engine
NOTE: The engine was shipped from the factory filled with
oil. Check the level of the oil. Add oil as needed.
See the engine manufacturer's instructions for the type
of petrol and oil to use. Before you use the unit, read the
information on safety, operation, maintenance, and storage.
WARNING: Follow the engine manufacturer's
instructions for the type of petrol and oil to use.
Always use a safety petrol container. Do not smoke
when adding petrol to the engine. When inside an
enclosure, do not fill with petrol. Before you add
petrol, stop the engine. Let the engine cool for
several minutes.
murray.com